Jungheinrich ETM 110 Operating Instructions Manual page 39

o
Behaviour in unusual situations
m
Proceed as follows, if there is danger of the floor conveyor tipping over.
– Press the upper part of your body against the the backrest.
– Keep both hands at the steering wheel and use your feed for
additional support.
– Bend your body against the falling direction.
o
Operating instruction of the safety belt
Before starting up the floor conveyor, pull the belt continuously
out of the reel-up device and let it catch in with the belt fitting
tight to your body.
f
The belt must not be twisted when being fastened.
When operating the floor conveyor (e.g. driving, lifting, lowering,
etc.) always try to sit with your back having contact with the
backrest.
The locking mechanism of the reel-up device permits enough
freedom of motion when sitting.
f
If you are sitting on the front edge of the seat, protecton will de-
crease due to the belt band being too loose.
A
Use the belt only for protecting one person.
– After using the belt, press the red button and direct the belt
locking tongue back to the reel-up device with your hand.
o
Behaviour for starting up the floor conveyor on steep slopes
The locking mechanism blocks the belt drawing mechanism if the floor conveyor is
parked on a steep slope. The belt can no longer be pulled out of the reel-up device.
A
Drive the floor conveyor carefully out of its slope position and fasten the belt.
E 8