Table of Contents
Advertisement
PROGRAMMING thE GENERAl REcEIVER sEttINGs:
The receiver can be programmed using a suitable HoTT transmitter or the SMART-BOX (Order No.
33700).
RECEIVER
>Type of Model:
ALARM VOLT:
ALARM TEMP:
max altitude:
>Period:
>SUMD at K8:
LANGUAGE:
Display
RECEIVER 1.0
Type of Model
ALARM VOLT.
ALARM TEMP.
Max. altitude
PERIOD
SUMD at CH8
LANGUAGE
Model type selection (type of model): here you can choose the model type.
By selecting "Plane" you will be able to access the gyrosettings for surface models, as described in
chapter 4.
The selection "Heli" will be made available through a future software update. It will enable a receiver-
integrated flybarless system, which can be adjusted inside the transmitters telemetry settings.
low-voltage warning (AlARM VOlt): if the receiver voltage falls below the set value, a low-voltage
warning is generated by the transmitter's RF module in the form of the "general alarm tone": a regular
beeping at a rate of about one per second; alternatively the speech output message "Receiver voltage".
temperature warning (AlARM tEMP): if the receiver temperature exceeds the set temperature
threshold, a warning is generated by the transmitter's RF module in the form of the "general alarm tone":
a regular beeping at a rate of about one per second; alternatively the speech output message "Receiver
temperature".
Maximum altitude (Max. altitude): at this point you can enter a maximum altitude, at which an alarm
is triggered, either via the transmitter's RF module in the form of the "general alarm tone": a regular
beeping at a rate of about one per second; alternatively the speech output message "Height". Note:
the model's actual height is adopted as zero when the receiver is switched on; the indicated height is
therefore the altitude relative to the launch point.
24
3.2 REcEIVER sEt-UP MENU
1.0
< >
The receiver set-up menu appears in the "Telemetry" menu
Plane
under SETTINGS / DISPLAYS; alternatively - if you are using a
3.8V
SMART-BOX - under SETTING & DATAVIEW. The method of
accessing this menu is described in the operating instructions
70°C
supplied with your transmitter or the Smart-Box.
125m
10ms
No
english
Explanation
1.0 indicates the version of the receiver's firmware -
Selection of modeltype
Alarm threshold for the receiver's low voltage
warning
Receiver overheating warning
maximum altitude
Cycle time (frame rate) in ms
Digital sum signal at channel 8
Select menu language
Manual Receiver GR-24PRO 3xG+3A+3M+Vario Graupner HoTT 2. 4
settings
Plane, Heli
2.5 - 24.0 V
Default setting: 3.8 V
50 - 80° C
Default setting: +70° C
0 - 2500 m
in 25 m increments
10 / 20 ms
Yes / No
German, English, French,
Italian or Spanish
Advertisement
Table of Contents
