Table of Contents
Advertisement
move the left wing down through at least 45°.
•
This process defines the one axis and direction; now you must repeat the procedure for the other
two axes.
•
The gyro axis 1, 2 or 3 is now displayed in the 'Aileron / Elevator / Rudder' display; a negative
prefix will appear if servo reverse is activated.
Once all three axes are defined, the display automatically reverts to 'New setting: no'.
WARNING: once you have completed this procedure, it is absolutely essential to check that
all the gyros are working in the correct direction. This is accomplished by moving the model
around all three axes in turn, and checking the control surface deflections - see diagrams
below. You must not fly the model before doing this: crash hazard!
Model movement
Model movement
Model movement
28
ElEVAtOR
Control surface response (seen from the tail)
RUDDER
Control surface response (seen from the tail)
AIlERON
Control surface response (seen from the tail)
Manual Receiver GR-24PRO 3xG+3A+3M+Vario Graupner HoTT 2. 4
Advertisement
Table of Contents
