Transferring A Call - Sony PCS-11 Operating Instructions Manual

Note
Only "Resume Call" and "Disconnect" are available while the call is held. However,
when the remote party has operated the system to enter the hold mode, you cannot
resume the held call.

Transferring a Call

You can transfer a call to another remote party during a videoconference when
connected by SIP.
1
Press the CONNECT/DISCONNECT (
Commander during communication.
The following submenu appears.
Disconnect
2
Select "Transfer" using the V, v, B or b button and the PUSH ENTER
button on the Remote Commander.
The remote terminal in communication enters the hold mode. The hold mode
continues until the call transfer is completed.
Notes
• "Resume Call" is not available on the remote terminal in the hold mode. Only
"Disconnect" is available on that terminal.
• If you operate the system to transfer a call during reception of the data via the
Data Solution Box or the White Board, the reception is cancelled and will not be
restored after call transfer is completed.
The following submenu appears on the monitor screen of the local system.
154
Starting a Videoconference Using SIP
Hold
Transfer
Disconnect
Cancel
/ ) button on the Remote
Phone Book
Dial
Cancel
Phone Book
Dial