APPA A10N Instruction Card

A10N Instruction
Clamp Meter Card
Warning Safety sheet
. . . . . . . . . .
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . .
. . . . . . . . .
Read First

Safety Information

To ensure safe operation and service
of the Meter, follow these instructions.
Failure to observe warnings can result
in severe injury or death.
- Avoid working alone so assistance can
be rendered.
- Do not use test leads or the Meter if
they look damaged.
- Do not use the Meter if the Meter is
not operating properly or if it is wet.
- Use the Meter only as specified in the
Instruction card or the protection by
the Meter might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
- Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Symbols as marked on the Meter
and Instruction card
Risk of electric shock
See instruction card
DC measurement
Equipment protected by double or
reinforced insulation

Battery
Earth
AC measurement
Conforms to EU directives
Caution
If the meter is used in the vicinity of
equipment which generates electromag-
netic interference, the display may
become unstable or the measurements
show may be subject to large errors.
Off / On
Auto Power Off
10min
Auto Power Off disable :
Press backlight buttons than switch the
rotary knob to power on the Meter.
AC V / DC V
Resistance