Dmx Linking; Dmx Addressing - SHOWTEC 43552 User Manual

Spectral PC 1200Z IP65

DMX Linking

To connect multiple devices on one DMX data link, follow the steps below:
01) Use a 3-pin/5-pin DMX cable to connect the DMX OUT connector of the lighting controller to the
DMX IN connector of the first device.
02) Connect the first device's DMX OUT connector to the second device's DMX IN connector with a
3-pin/5-pin DMX cable.
03) Repeat step 2 to connect all devices in a daisy-chain as shown in Fig. 13.
04) Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data
link.

DMX Addressing

In a setup with multiple devices, make sure that you set the DMX starting address of each device
correctly. The Spectral PC 1200Z IP65 has 4 personalities: HSIC (9 channels), SSP (9 channels), TOUR (12
channels), and TR16 (17 channels).
If you want to connect multiple devices on one data link and use them in 17-channel mode, for
example, follow the steps below:
Set the starting address of the 1
02) Set the starting address of the 2
03) Set the starting address of the 3
04) Continue assigning the starting addresses of the remaining devices by adding each time 17 to the
previous number.
Make sure that you do not have any overlapping channels in order to control the Spectral PC 1200Z IP65
correctly. If two or more devices are addressed similarly, they will work similarly.
Product code: 43552
device on the data link to 1 (001).
st
device on the data link to 18 (018), as 1 + 17 = 18.
nd
device on the data link to 35 (035), as 18 + 17 = 35.
rd
18
Fig. 13