Unload And Remove Media - Canon Arizona 2300 Series Operation Manual

Unload and Remove Media

Unload and Remove Media
Introduction
This section explains all of the actions associated with how to cut and unload media when there
is still some media left on the supply roll.
Unload Media Summary
The following actions are associated with unloading media:
• A) Initiate Unloading
• B) Cut the Media
• C) Remove Media from Take-up Shaft in Printer or Remove Take-up Shaft
• D) Remove Supply Shaft From Printer
• E) Remove Media Roll Or Empty Core From Media Shaft
Before you begin
CAUTION
Lifting a media roll has always to be done with the help of an external lifting tool.
Lifting media (e.g. rigids) has to be done with the help of an external lifting tool or at least two
persons.
NOTE
When you select the Unload icon the media will advance automatically by a preset amount. This
distance is determined by the Move Media on Unload value in the Settings Roll Module tab. The
default value will advance the media to a position past the Media Cut Guide so that the printed
image is not cut. To manually increase this distance you can use the foot pedal to advance the
media, but only before the Unload is selected. Once Unload is selected the foot pedals will not
work until you Initiate a new RMO pint job.
Required tools
5mm hex key
Procedure
1. Click on the Roll Manager icon to bring up the Roll Media Manager.
2. Select the Unload icon in the Roll Media Manager to release the tension.
3. Cut the media using the cutter guide.
4. Click on OK to proceed.
5. If you want to remove the printed images without removing the take-up roll from the printer you
can press the left pedal to rotate the take-up media shaft in the reverse direction. You can then
roll up the media by hand as it comes off the take-up roll.
6. To remove the take-up roll without manually rolling up the media, tap the right pedal
momentarily to rotate the take-up shaft one revolution to the unlocked position in the forward
direction.
7. If you want to change the supply shaft, momentarily press the left pedal to rotate the shaft to the
unlocked position.
8. Remove the supply shaft from the printer by pulling it towards you. Pull one end out at a time.
9. Place the media shaft on a suitable work surface.
10. Unlock the media shaft core locks using a 5 mm hex key.
11. Slide the media core off the shaft.
108 Chapter 5 - Roll Media Option