Print Rulers On The Table - Canon Arizona 2300 Series Operation Manual

Print rulers on the table

Print rulers on the table
Introduction
The printer software provides various rulers to be printed on the table. The table rulers are also
available for download from our website: https://graphiplaza.cpp.canon
Available rulers
The versions below are available for metric and imperial, for GTF and XTF.
Bottom Ruler - 2 Origins
Bottom Ruler - Left Origin
Bottom Ruler - Right Origin
Left Side Ruler
Right Side Ruler
Full Table - 2 Origins
Full Table - Left Origin
Full Table - Right Origin
NOTE
Orientation for left, right, bottom of the table is when you are on the ink bay side.
Procedure
1. Select Tools - Special Prints in the printer software.
2. Select the type of ruler you want to print and add it to the print job list.
3. With no media present, print the zone map directly onto the printer table.
74 Chapter 4 - Operate the Printer
Horizontal ruler with two zero points.
0 1250 mm | 49"
Horizontal ruler with one zero point on the left.
This assembles the rulers for the non flow ta-
bles
0 2500 mm | 98"
Horizontal ruler with one zero point on the
right.
2500 mm | 98" 0
Vertical ruler for the left side of the table
Vertical ruler for the right side of the table
Bottom Ruler - 2 Origins, Left Side Ruler, Right
Side Ruler + Top ruler in one print
Bottom Ruler - Left Origin, Left Side Ruler,
Right Side Ruler + Top ruler in one print
Bottom Ruler - Right Origin, Left Side Ruler,
Right Side Ruler + Top ruler in one print
0