Canon Arizona 2300 Series Operation Manual page 99

It is very important that the media is wound properly onto the core when it arrives from the
manufacturer. The media must be wound straight, tight and even from one end to the other. If
you have a roll that is not even, before loading it, hold the roll in a vertical position and carefully
and evenly drop one end onto the floor, then tap lightly a few times. If any edges are crushed,
unwind and throw away the crushed area or cut off the crushed end of roll. If it is not possible to
repair, do not use it.
NOTE
If media has been stored on its side and has a pronounced flat side, do not use it as it will not
advance evenly.
Required tools
5mm hex key (supplied with the Roll Media Option)
Load Supply Media Roll and Position a Take-up Shaft
Procedure
1. Place an empty media shaft on a suitable flat work area, positioned as shown, so that the 5mm
hex key is inserted on the right side of the shaft to lock and unlock the core locks.
[22] Unlock the Media Shaft Core Locks
2. Turn counterclockwise with the supplied 5mm hex key (1) to unlock the media shaft core locks (2).
3. Slide a new roll of media onto the supply shaft.
4. Roughly center the roll on the shaft, and then insert the shaft into the Supply (bottom) position on
the printer. Insert one end of the shaft at a time.
NOTE
Load the shaft with the core lock and coupler end on the right side of the printer.
2 1
Chapter 5 - Roll Media Option
Load Media
99