Table of Contents
Advertisement
Appendix
Configurable parameter navigation tree
This section provides an overview of the parameter tree structure. You can navigate around the tree
structure, and set parameter values, using the station control panel (SCP) jogstick. Configurable parameters
are described in more detail (including descriptions, ranges, defaults and units) later in this manual (► page
8-42).
Parameters can also be accessed and set using the blue ARROW Support Tool (► page 5-1).
CID parameter tree
Type (Type)
Calib (Calibration)
0 low (Axis 0 low)
0high (Axis 0 high)
0 mid (Axis 0 mid)
1 low (Axis 1 low)
1high (Axis 1 high)
1 mid (Axis 1 mid)
2 low (Axis 2 low)
2high (Axis 2 high)
2 mid (Axis 2 mid)
3 low (Axis 3 low)
3high (Axis 3 high)
3 mid (Axis 3 mid)
4 low (Axis 4 low)
4high (Axis 4 high)
4 mid (Axis 4 mid)
5 low (Axis 5 low)
5high (Axis 5 high)
5 mid (Axis 5 mid)
Load (Load ship values)
Save / Relod (Save and Reload)
Save (Save to ship)
LoadF (Load factory values)
SWVer (Software version)
BbVer (Boot Block Software version)
Amend (Amendment)
PCBAm (PCB amendment)
8-36
HTX30 Product Manual
Advertisement
Table of Contents
