Table of Contents
Advertisement
HTX30 Product Manual
7 - Maintenance
In this section
General .................................................................................................................................. 7-1
Preservation: Pre installation ................................................................................................ 7-3
Service Intervals..................................................................................................................... 7-4
Servicing details ..................................................................................................................... 7-4
Servicing details (electronic system) ..................................................................................... 7-7
General
This section describes standard maintenance procedures for the blue ARROW electronic control system.
This maintenance schedule has been prepared for normal operating conditions. If the jet unit is being used
where the control equipment is exposed to salt spray (e.g. An open vessel), linkages should be greased on a
weekly basis.
Electronic modules do not contain user serviceable parts, maintenance is normally done by replacing the
module.
Threaded fasteners
Tighten all threaded fasteners to the correct torque as specified in the appendix (► page 8-13), and
any relevant assembly drawing.
Thread locking agents
Some fasteners require thread locking agents to prevent loosening.
Before using any Loctite product, please read and understand the Loctite Application Guide (►
page 8-3).
The Loctite application guide describes most Loctite applications.
The relevant assembly drawings will show any special Loctite applications.
Tightening torques
7-1
Maintenance
Advertisement
Table of Contents
