Monitor Configurations And Commands - AML Oceanographic AML-3 User Manual

set sound inc <value>
set pressure inc <value>
set [conduct | sound | pressure] threshold
<value>

5.2 Monitor Configurations and commands

Command
monitor
mmonitor
scan
mscan
set monitor robust [y | n]
set monitor auto <seconds>
set monitor startup [y | n]
AML Oceanographic Ltd.
Set sound velocity increment.
Set pressure increment.
Set the threshold for water detection to begin
automatic logging. Valid detection parameters
are "conduct", "sound", and "pressure". By
default pressure is set to 99999.99 and it is
not recommended to detect water by
pressure unless there are no sound velocity
or conductivity sensors installed.
Note: This is a secure command.
Description
Start streaming data on the user terminal. Hit
<enter> to exit monitor, hit <enter> three
times to exit monitor when in robust mode.
Start streaming data in AMLx format.
Print a single line of the latest sensor data.
Print a single line of the latest sensor data in
AMLx format.
Enable/disable robust monitor mode. When
enabled, monitoring is halted via 3 carriage
returns.
When disabled, a single carriage return will
halt monitoring.
Monitoring will begin automatically after an
interval of inactivity. Setting to "0" disables
auto monitor.
Min value: 5
This command applies only to monitoring via
serial connection
Enable/disable monitoring on startup. When
enabled the instrument will start monitoring
when powered on.
25 / 43