Install Tip/Guard Assembly (If Not Installed) - Graco 258850 Operation Manual

Setup
Install Tip/Guard Assembly
(if not installed)
Reversible Tip Selection Chart
MATERIALS
*Thin
Thin stains,
semi-transparent stains
411
*Install Fine-Finish Optimizer, see page 9.
1. Engage trigger lock and put prime/relief valve UP to
release pressure. Then remove Tip/Guard Assembly.
ti14994a
3A1204E
Medium Heavy
Enamels, solid Heavy latex
stains, thin latex
213, 413 315, 515
ti14999a
2. Install filter to Spray Tip/Guard Assembly (make sure
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
ti14775a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid damage to the filter.
3. Screw Tip/Guard Assembly onto sprayer. Tighten
retaining nut until completely engaged with sprayer.
NOTICE
The tip is a permanently attached to the Tip/Guard
Assembly. Removal will result in damage.
ti14997a
11