Install Tip/Guard Assembly; Shoulder Strap Installation - Graco 258870 Manual

Install Tip/Guard Assembly (if not installed)

Install Tip/Guard Assembly

(if not installed)
Reversible Tip Selection Chart
MATERIALS
*Thin
Thin stains,
semi-transparent stains
311
*For thin materials install Fine-Finish Optimizer, page 10.
1. Engage trigger lock and put control lever UP to release
pressure in the sprayer.
ti14994a
2. Install filter to Spray Tip/Guard Assembly. Make sure
filter is fully installed into sprayer. NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
ti14775a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid splattering material or damage to the
filter.
3. Firmly screw Tip/Guard Assembly onto sprayer.
Tighten retaining nut until completely engaged with
sprayer. If Tip/Guard Assembly is not fully tightened,
poor spray results and possible damage to the sprayer
could occur.
3A0159A
Medium Heavy
Enamels, solid Heavy latex
stains, thin latex
315, 515 517
ti14999a
ti14997a
NOTICE
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.

Shoulder Strap Installation

1. Attach the metal eyelet to the back of the sprayer.
2. Open the velcro end of the strap, then route it through
the slot under the tip of the sprayer.
3. Route velcro up through the metal triangle, then fold
down and attach velcro to strap.
13