Install Spray Tip/Guard Assembly (If Not Installed); Getting Started With Basic Techniques; Triggering Sprayer - Graco 16N664 Owner's Manual

Install Spray Tip/Guard
Assembly (if not installed)
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing fluid
and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before
cleaning, checking, or servicing the equipment.
1. Engage trigger lock and put prime/spray valve UP to
release pressure.
ti18866a
2. Install filter to spray/tip guard assembly.
NOTE: Spray tip filter is reverse-threaded. Turn left (or
counter-clockwise) to install. Turn right (or clockwise)
to remove.
ti14775a
Make sure spray tip filter is completely screwed into the
spray/tip guard assembly to avoid damage to the filter.
Do not use a damaged filter or poor sprayer performance
may result.
Do NOT place hands in front of tip.
3. Screw spray/tip guard assembly onto sprayer. Tighten
retaining nut until completely engaged with sprayer. Do
not overtighten nut.
The spray tip is permanently attached to the spray/tip
guard assembly. Removal will result in damage.
12
ti16700a
ti14775a
NOTICE
ti16717a
ti14997a
NOTICE

Install Spray Tip/Guard Assembly (if not installed)

Getting Started with Basic
Techniques
Use a piece of scrap cardboard to practice these basic
spraying techniques before you begin spraying the surface.
• Hold sprayer 10 in. (25 cm) from surface and aim
straight at surface. Tilting sprayer to direct spray angle
causes an uneven finish.
(25 cm)
10 in.
even
finish
• Flex wrist to keep sprayer pointed straight. Fanning
sprayer to direct spray at angle causes uneven
finish.
even finish
ti18880a
NOTE: How fast you move the sprayer will affect spray
application. If material is pulsating, you are moving too fast.
If material drips, you are moving too slow. See Trouble-
shooting, page 23.

Triggering Sprayer

Pull trigger after starting stroke. Release trigger before end
of stroke. Sprayer must be moving when trigger is pulled
and released.
Start Moving Pull Trigger
thick
ti14780a
uneven
ti18863a
finish
thin
thin thick
ti14988a
ti18886a
Release Trigger
3A2853A
thin
ti18887a