Table of Contents
Advertisement
Shutdown and Cleaning
6. Disconnect trigger lock and trigger sprayer for
approximately 15 seconds. Engage trigger lock.
ti14994a
7. Discard contaminated fluid and refill with appropri-
ate flushing fluid.
8. Disengage trigger lock, reverse tip to UNCLOG
position, and pull trigger for 5 seconds to prime
sprayer.
ti14995a
9. Put prime/relief valve DOWN to spray position.
Trigger sprayer into waste area until no paint
appears in water or flushing fluid.
ti15425a
To avoid serious injury or damage to equipment, do not
expose the sprayer electronics to flushing solvents.
Keep sprayer at least 25 cm above the rim of the
container when flushing.
Keep spray area well-ventilated. Keep a good supply of
fresh air moving through the area.
3A1456A
10. Engage trigger lock and put prime/relief valve UP to
release pressure.
11. Remove material cup and discard used fluid.
12. Remove Spray Tip/Guard Assembly and clean with
water or flushing fluid. A soft brush can be used to
loosen and remove dried material if needed.
ti14991a
The tip is permanently attached to the guard. Removing
the tip from the guard will result in damage to the tip
assembly.
13. Replace tip assembly.
14. If you used the Fine-Finish Optimizer, remove and
clean optimizer with water (or flushing fluid) and a
brush. Reconnect intake tube.
ti15491a
Cleaning Sprayer Exterior
•
Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid.
Do NOT submerge the sprayer.
ti15529a
Tips
•
Tips will require replacement depending on
abrasiveness of paint.
•
Do not spray with worn tip. See Troubleshooting,
page 20.
ti14994a
ti15003a
NOTICE
15
Advertisement
Table of Contents
