Table of Contents
Advertisement
Troubleshooting
Problem
Sprays with poor results
Paint leaks from sprayer trigger area. Sprayer has reached its maximum
Battery is discharged but charger still
displays green light when battery is
inserted.
Spray Pattern Diagnostics
Problem
Spray pattern is pulsating:
Spray pattern has tails:
Spray pattern has dripping:
3A1456A
Tip is partially clogged
Tip is not in correct position
Incorrect tip for application of
material.
Tip filter is partially clogged
Suction Tube screen is partially
clogged.
Fine Finish Optimizer is partially
clogged.
Fine Finish Optimizer is installed
while using an incompatible material.
Tip is worn or damaged
Inlet or Outlet Valves are worn.
life.
Damaged battery.
Cause
Fine Finish Optimizer is installed while using
an incompatible material.
Operator is moving too fast while spraying.
ti15524
Fine Finish Optimizer is installed while using
an incompatible material.
Fine Finish Optimizer is partially clogged.
Material not compatible with sprayer.
ti15526
Inlet or Outlet Valves are worn.
Sprayer is moving too slow for material.
Sprayer is too close to target surface.
Holding trigger while changing spray
direction.
Incorrect tip for application of
ti15522
material.
Tip is worn or damaged.
Cause
See Unclogging Tip/Guard
Assembly, page 13.
Rotate tip to SPRAY position.
See Reversible Tip Selection
Chart, page 11.
Clean or replace Suction Tube. See
page 14.
Clean or replace Fine Finish Opti-
mizer. See page 9.
Make sure compatible material is
being used. See Reversible Tip
Selection Chart, page 11.
Replace tip. See Install Tip/Guard
Assembly, page 11.
See Repair Kit, page 18.
Replace sprayer.
Replace battery.
Make sure material is compatible. See Revers-
ible Tip Selection Chart, page 11.
Slow speed of movement.
Make sure compatible material is being used.
See Reversible Tip Selection Chart, page 11.
Clean or replace Fine Finish Optimizer.
See page 9.
Switch material.
See Repair Kit, page 18.
Move sprayer faster while spraying.
Move sprayer away from surface (10 in).
Release trigger when changing directions.
See Reversible Tip Selection Chart, page 11.
Replace tip. See Install Tip/Guard Assembly,
page 11.
Solution
Clean or replace filter. See page 13.
Solution
21
Advertisement
Table of Contents
