Firepower; Log Into The Firepower Management Center, On Page; Management Center - Cisco Firepower 1010 Getting Started Manual

Firepower Threat Defense Deployment with a Remote FMC
Central Administrator Pre-Configuration Using the CLI
Connect to the FTD CLI to perform initial setup. When you use the CLI for initial configuration, only the
Management and FMC access interface settings are retained.
Before you begin
Deploy and perform initial configuration of the FMC. See the
know the FMC IP address or hostname before you set up the FTD.
Procedure
Step 1 Power on the device.
Step 2
Connect to the FTD CLI, either from the console port or using SSH to the Management interface, which
obtains an IP address from a DHCP server by default. Because this procedure requires you to change the
Management interface network settings, we recommend using the console port so you do not get disconnected.
The console port connects to the FXOS CLI. The SSH session connects directly to the FTD CLI.
Step 3 Log in with the username admin and the password Admin123.
At the console port, you connect to the FXOS CLI. The first time you log in to FXOS, you are prompted to
change the password. This password is also used for the FTD login for SSH.
Note
Example:
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
All manuals and user guides at all-guides.com

Firepower

Central administrator:

Management Center

99.
Cisco Commerce Obtain Licenses for the Firepower Management Center, on page
Workspace licenses.
Smart Software Obtain Licenses for the Firepower Management Center, on page
Manager a license token for the FMC.
Firepower Obtain Licenses for the Firepower Management Center, on page
Management Center the FMC with the Smart Licensing server.
Firepower Register the FTD with the FMC, on page
Management Center
Firepower Configure a Basic Security Policy, on page
Management Center
If the password was already changed, and you do not know it, then you must reimage the device to
reset the password to the default. See the
Central Administrator Pre-Configuration Using the CLI

Log Into the Firepower Management Center, on page

135.
102.
FMC getting started
FXOS troubleshooting guide
Cisco Firepower 1010 Getting Started Guide
134: Buy feature
134: Generate
134: Register
guide. You will need to
for the reimage procedure.
127