Cisco Firepower 1010 Getting Started Manual page 153

Firepower Threat Defense Deployment with a Remote FMC
Procedure
Step 1 To log into the CLI, connect your management computer to the console port. The Firepower 1000 ships with
a USB A-to-B serial cable. Be sure to install any necessary USB serial drivers for your operating system (see
the Firepower 1010
settings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
You connect to the FXOS CLI. Log in to the CLI using the admin username and the password you set at
initial setup (the default is Admin123).
Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 2
Access the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see the
Step 3 To exit the FTD CLI, enter the exit or logout command.
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Troubleshoot Management Connectivity on a Data Interface
Model Support—FTD
All manuals and user guides at all-guides.com
hardware guide). The console port defaults to the FXOS CLI. Use the following serial
Cisco Firepower Threat Defense Command
Troubleshoot Management Connectivity on a Data Interface
Reference.
Cisco Firepower 1010 Getting Started Guide
151