Cisco Firepower 1010 Getting Started Manual page 99

Firepower Threat Defense Deployment with FMC
shown in the network deployment section, the inside interface acts as the management gateway. In this
case, you should set the gateway IP address to be the intended inside interface IP address; you must later
use FMC to set the inside IP address.
• If your networking information has changed, you will need to reconnect—If you are connected with
SSH but you change the IP address at initial setup, you will be disconnected. Reconnect with the new
IP address and password. Console connections are not affected.
• Manage the device locally?—Enter no to use FMC. A yes answer means you will use Firepower Device
Manager instead.
• Configure firewall mode?—We recommend that you set the firewall mode at initial configuration.
Changing the firewall mode after initial setup erases your running configuration.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Please enter 'YES' or press <ENTER> to AGREE to the EULA:
System initialization in progress.
You must change the password for 'admin' to continue.
Enter new password: ********
Confirm new password: ********
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]:
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.10.10.15
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.192
Enter the IPv4 default gateway for the management interface [data-interfaces]: 10.10.10.1
Enter a fully qualified hostname for this system [firepower]: ftd-1.cisco.com
Enter a comma-separated list of DNS servers or 'none' [208.67.222.222,208.67.220.220]:
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: no
Configure firewall mode? (routed/transparent) [routed]:
Configuring firewall mode ...
Update policy deployment information
- add device configuration
- add network discovery
- add system policy
You can register the sensor to a Firepower Management Center and use the
Firepower Management Center to manage it. Note that registering the sensor
to a Firepower Management Center disables on-sensor Firepower Services
management capabilities.
When registering the sensor to a Firepower Management Center, a unique
alphanumeric registration key is always required.
a sensor to a Firepower Management Center, you must provide the hostname or
the IP address along with the registration key.
'configure manager add [hostname | ip address ] [registration key ]'
All manuals and user guides at all-guides.com
Please stand by.
Complete the FTD Initial Configuration
In most cases, to register
Cisco Firepower 1010 Getting Started Guide
97