Dmx Operation - EuroLite LED CBB-6 Manual

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 21 control channels.
However, it can also be switched to a mode with 2, 3, 5, 9 or 18 channels if different functions are required.
To be able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2 CH (2 DMX channels), 3 CH (3 DMX channels), 5 CH (5 DMX channels), 9 CH (9
DMX channels), 18 CH (18 DMX channels) or 21 CH (21 DMX channels). Use the buttons UP and
DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 A dot will light up when DMX signals are being received. If no control signals are available, the display
will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
2-channel mode
Channel Value
1
000 – 255
Master dimmer
000 – 009
010 – 019
020 – 029
030 – 039
040 – 049
050 – 059
060 – 069
070 – 079
080 – 089
2
090 – 099
Preset colors
100 – 109
110 – 119
120 – 129
130 – 139
140 – 149
150 – 159
160 – 169
170 – 179
180 – 255
Function
Total brightness 0-100%
No function
Red
Green
Blue
Yellow
Magenta
Cyan
Dark orange
Green yellow
Salmon
Turquoise
Light green
Orange
Straw
Lavender
Light blue
Dark blue
Pink
White
26/32 00119899, Version 1.1