Dmx Operation - EuroLite LED PIX-72 User Manual

Reset to default settings
The device can be reset to factory settings. Press the MENU button so many times until rset is indicated in
the display. Confirm with the ENTER button.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 12 control channels.
However, it can also be switched to a mode with 3, 5 or 6 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Chnd is indicated on the display. Confirm with the ENTER
button.
2 The display indicates 3 CH (3 DMX channels), 5 CH (5 DMX channels), 6 CH (6 DMX channels), 12-1
CH (12 DMX channels) or 12-2 CH (12 DMX channels). Use the buttons UP and DOWN to select the
desired DMX channel mode. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address Addr. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
4 A dot will flash when DMX signals are being received. If no control signals are available, the dot will not
flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronously.
The LEDs of the device are organized into LED segments, each of which can be individually controlled with
the following DMX protocol. The segments are arranged as shown in the graphic below.
1
Functions in DMX mode
3-channel mode
Channel
1
2
3
2
Value Function
000 – 255 Red 0-100%
000 – 255 Green 0-100%
000 – 255 Blue 0-100%
25/28
3 4
00135837, Version 1.0