Wireless Dmx Operation - EuroLite Multiflood IP 8x10W RGBW Wash CRMX User Manual

Wireless DMX operation

CRMX allows creating reliable point-to-point and multipoint installations over large distances and in any
environment. The DMX signal is fed to a transmitter which sends it via RF. Receivers with the same transmission
protocol receive the RF signal and distribute it as a DMX signal. Adaptive frequency hopping enables interference-
free operation alongside Bluetooth and Wi-Fi. Depending on the ambient conditions the range is up to 600 m. To
optimize range and performance maintain a line-of-sight between the transmitter and receiver and position the
devices at least 1 m above the audience, trees and other obstacles.
CRMX status
The CRMX receiver's status is shown in the display.
Display
CRMX
Pairing with a transmitter
1 To pair with CRMX compatible transmitters, enable CRMX in the menu settings (Wireless > CRMX > ON).
Start the pairing process as described in the operating instructions of the transmitter. Pairing is then completed
automatically.
The assignment to the transmitter is kept memorized even after disconnecting the power supply. After switching
on again, the unit therefore tries to re-establish the connection to the transmitter automatically.
2 To unlink the device, select the option Wireless > Unlink in the menu settings and press ENTER for 3
seconds.
TX
DMX
Slow flashing = pairing process / flashing stops = paired
Lights permanently = transmission path not active
Receiver off
Slow flashing = DMX signals are being received
Function
31/36 00151618, Version 1.0