Table of Contents
Advertisement
Available languages
Available languages
Control Board
The Control Board offers several features: you can e. g. easily set the starting address.
The main menu is accessed by pressing the Mode button. Browse through the menu by pressing Up or
Down. Press the Enter button in order to select the desired menu. You can change the selection by pressing
Up or Down. Confirm every selection by pressing the Enter button. You can leave every mode by pressing
the Mode button. The functions provided are described in the following sections.
Main menu
DMX Set
Address
Mode Set
Slve1/Slve2
Show Set
Show 1/2/3/0
Sound Mode
Sound Sense
No DMX Set
Blac/Auto/Sound/Hold
Back Led
Light
Fixture Reset
DMX operation
Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 10 control channels. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1
Press the UP or DOWN button so many times until DMX Set Address is indicated on the display.
Confirm with the ENTER button.
2
Now the display calls up the menu item for the DMX starting address: 001.
3
Use the buttons UP and DOWN to set the address. Confirm with the ENTER button.
4
The display will flash when DMX signals are being received.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Sub menu
Function
001-512
DMX address setting
Master/Slave setting
Mast: Master-Mode setting
Mast/
Slve1: Slave-Mode 1
Slve2: Slave-Mode 2
With this function, you can define the device as slave.
Internal programs 0 – 3 (Auto)
ON/OFF
Sound controlled mode
0-100
Microphone sensitivity (increasing)
Status if no DMX-signal is received
Blackout/Auto/Sound/Hold
Display deactivation
OFF/ON
ON - Display always on
OFF - Shuts off the display after a few seconds
Yes/No
Reset
26/32
131193.docx, Version 1.0
Advertisement
Table of Contents
