Omron V460-H Series Connection Manual page 10

5. Applicable Products and Device Configuration
Precautions for Correct Use
Obtain the latest version of the Sysmac Studio Project File from OMRON in advance.
(Contact OMRON for information on how to obtain this file.)
Note
The configuration may not be reproduced if the system component models or versions differ.
Check your configuration and, if there is any difference in the models or versions, contact
OMRON.
Note
This document assumes that the USB is used to connect the controller. For information on
how to install the USB driver, refer to A-1 Driver Installation for Direct USB Cable Connection
in Appendices of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
Note
Refer to the Industrial Switching Hub W4S1 Series User Manual (0969584-7) for power
supply specifications that can be used for 24 VDC power supply (for the switching hub).
7