Advertisement
4-6
Desk Station V Plus User's Manual
Turning the Computer On and Off
Turning the Computer On
AC-IN
On
Power Switch
On
Power Indicator
This section describes how to turn the computer on and off when it is
connected to the Desk Station V Plus. Before you switch on the computer's
power, make sure you've completed all appropriate setup steps from the
preceding chapter. You should have all the peripherals you plan to use
already attached and powered on. Specifically, if you have installed a SCSI
device in the expansion bay and/or attached SCSI devices to the SCSI port,
you must turn all of them on before turning the System/Desk Station V Plus
on. Also, the SCSI interface cable attached to the SCSI port should be
connected to at least one SCSI device and properly terminated. If it is not,
remove it.
If your computer is not running with Windows 95, turn Resume Mode off
before you turn the power off. Turn Resume Mode off by pressing Fn + F3
or using MaxTime. For further instructions, consult your computer's User's
Guide.
Follow these steps to turn the computer on. These instructions assume the
computer is not in Resume Mode.
1 Connect the power cord to the AC-IN socket on the back of the Desk
Station V Plus and to a live wall outlet.
The Desk Station V Plus's power indicator glows orange and the
computer's DC-IN indicator glows green.
If the computer's DC-IN indicator does not glow green, there is a power
supply problem. Refer to the "Troubleshooting" chapter to resolve the
problem.
2 Press either the power switch on the front of the Desk Station V Plus or
the power switch of the computer.
If the computer is correctly attached, both the computer and Desk Station
V Plus are turned on and both the desk station's power indicator and
the computer's power indicator turn green.
The message "TOSHIBA Desk Station ATTACHED" appears on the
display and the computer's startup routine proceeds normally.
Advertisement
