Advertisement
Removing a SelectBay Module
PUSH
SelectBay Release
Button
SelectBay Eject
Lever
SelectBay Eject Lever
Preparing the Desk Station V Plus
3 Insert the module into the SelectBay with the flat surface up and toward
the rear of the Desk Station V Plus. When the module is in most of the
way, push it all the way into the connector with firm and even pressure.
Make sure that the SelectBay module release button on the top pops up,
indicating the module is snugly seated in the SelectBay.
You are now ready to use your Desk Station V Plus with the SelectBay
module.
NOTE:
You cannot install two SelectBay modules of the same type
in the Desk Station V Plus and the computer.
To remove a SelectBay module from the SelectBay, follow these steps:
1 Turn the computer's power off and remove the computer from the Desk
Station V Plus.
2 Locate the SelectBay module release button and the SelectBay eject
lever on the top of the Desk Station V Plus.
SelectBay Module
Release Button
3 While pushing the SelectBay module release button, slide the SelectBay
eject lever towards the front.
The module partially ejects from the SelectBay.
4 Gently pull the module out of the SelectBay.
3-13
Advertisement
