Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Place the battery on the palmrest and keyboard assembly.
2. Align the screw holes on the battery to the screw holes on the palmrest and keyboard assembly.
3. Replace the three screws (M2x3) that secure the battery to the palmrest and keyboard assembly.
4. Adhere the hard drive Flexible Flat Cable on to the battery.
5. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Removing the 4-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
22
Removing and installing components
After working inside your
before working inside your
computer.
computer.