Steps
1. Place the I/O board on the palmrest and keyboard assembly.
2. Align the screw holes on the I/O board to the screw holes on the palmrest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the I/O board to the palmrest and keyboard assembly.
4. Connect the fingerprint reader board cable to the connector on the I/O board and close the latch.
5. Connect the I/O board power cable to the connector on the I/O board and close the latch.
Next steps
1. Install the
base
cover.
2. Reconnect the
SD
card.
3. Follow the procedure in
Hard drive assembly
Removing the hard drive assembly
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
The following images indicate the location of the hard drive assembly and provides a visual representation of the removal
procedure.
34
Removing and installing components
After working inside your
Before working inside your
computer.
computer.