Steps
1. Ensure that the battery cable has been disconnected from the system board.
2. Remove the six screws (M2x4.5) that secure the battery to the palm-rest assembly.
3. Remove the battery from the palm-rest assembly.
Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Place the battery on the palm-rest assembly.
2. Replace the six screws (M2x4.5) that secure the battery to the palm-rest assembly.
Next steps
1. Install the
2230 solid-state
2. Install the
2280 solid-state
3. Install the battery.
4. Follow the procedure in
drive. (if applicable)
drive. (if applicable)
After working inside your
computer.
27