Removing The Battery; Installing The Battery - Dell Latitude 14 Rugged Extreme Owner's Manual

the user has disabled S3 or the OS fails to enter S3 entering Sleep is not guaranteed. When the system
enters the sleep (S3) state, the battery LED continues to flash green/amber at the faster rate to indicate to
the user that a power source needs to be installed.
If the hot swap battery is not charged to a sufficient level or the temperature is outside the mentioned
range and the user performs a hot swap, the BIOS puts the system into the Sleep (S3) state and flashes
the battery LED at a faster green/amber rate.

Removing the battery

1. Follow the procedure in
2. To remove the battery:
a. Slide and open the battery bay press latch door [1, 2].
b. Press the blue battery release tab to release the battery [3].
c. Pull the blue tab on the battery to remove the battery from the computer [4].

Installing the battery

1. Insert the battery into the battery bay.
2. Close the battery bay press latch door.
3. Follow the procedure in
20
Before working inside your
After working inside your
computer.
computer.