Installing The Battery - Dell XPS 16 9640 Owner's Manual

Figure 18. Removing the battery
Steps
1. Disconnect the battery cable from the connector (BATT) on the system board, if not disconnected earlier.
2. Remove the six screws (M2x4.5) that secure the battery to the system board and palm-rest assembly.
3. Lift the battery off the palm-rest assembly.

Installing the battery

CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs) 41