Installing The 41 W Battery For Computers Shipped With A Plastic Chassis - Dell Inspiron 14 5440 Owner's Manual

Prerequisites
1. Follow the procedure in
NOTE: Ensure that your computer is in Service Mode. For more information see,
2. Remove the base cover for computers shipped with a plastic
About this task
CAUTION: Removing the battery resets the BIOS setup settings to default. It is recommended that you note the
BIOS setup settings before removing the battery.
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
Figure 36. Removing the battery
Steps
1. Peel the adhesive tape that secures the battery cable to the system board.
2. Disconnect the battery cable from the connector (BATT1) on the system board.
3. Remove the three screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4. Lift the battery off the palm-rest and keyboard assembly.
Installing the 41 W battery for computers shipped with a plastic
chassis
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Figure 37. Installing the battery
Before working inside your computer.
chassis.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your computer.
63