Operation; General Operation; Timer; Remote Operation - Dimplex Opti-V VISTA VST130-I Installation And User Manual

Operation

WARNING: This electric rebox must be properly installed before it is used.

General Operation

The mains switch controls the electricity supply to the replace. The mains switch must be in the on ( I ) position for the
replace to operate with or without heat.
The mains switch is located behind the front glass at the upper right corner. Remove the front glass to access the
switch.
When the replace is powered on the media bed, and ame screen will light up. This action may take up to 7 seconds.
NOTE:
The ame screen resets for 2-3 seconds, every 30 minutes.
NOTE:
The replace will retain the previously used settings after a power interruption.

Timer

The Timer is located behind the mirrored glass, at the bottom right of the replace.
The SD Card slot and the USB slot are located beside the timer on the media bed. It
is recommended to complete the 7-day programming before the glass installation.
NOTE: Ensure the timer cover is always tightly secured in place.
NOTE: Program the Timer prior to installing the mirrored glass. If the
Timer is not programmed for a 7 day operation it will remain in the
"MAN ON" mode. Refer to the Timer Operation section (p. 14) for more
information.

Remote Operation

The replace is supplied with a multifunction IR remote control.
NOTE:
To operate correctly, remove the plastic strip from
the remote control, and point the remote control towards the
front, right side of the replace.

Resetting the Temperature Cutoff Switch

Should the heater overheat, a manual limit cut-out will turn the unit off and it will not
come back on without being reset. It can be reset by turning the unit off at the main
disconnect panel and waiting 30 minutes before turning the unit back on.
CAUTION: If you need to continuously reset the heater, turn the unit off at the
main disconnect panel and contact technical support.
12 Dimplex