Install The Mirrored Glass - Dimplex Opti-V VISTA VST130-I Installation And User Manual

Installation
3

Install the Mirrored Glass

4
Wall Framing
Prepare a wall with a framed opening, following the dimensions
in the table below.
Framing Dimensions
Model
VST130 - I 1335 mm
VST130 – III 1335 mm
VST130 - I Installation
C
Width Height
A B
685 mm
A
B
Suction Cup
NOTE:
Remove the protective peel-off plastic before
attaching the suction cups and ensure the suction cups are
securely attached to the glass.
Attach the suction cups to the mirrored glass side where the
protective plastic was removed. Place the mirrored glass in the
top slot located at the back of the unit, then carefully place it in
the bottom slot at an angle to secure it.
Depth
(minimum)
C
400 mm
!
NOTE: Ensure the product is within 1m of a
power outlet.
CAUTION: This replace is NOT load-bearing.
Ensure the opening for the replace is framed
in such a way that the weight of the building
materials will not create pressure on the top of
the replace.
!
NOTE: The cord set is located at the bottom
right back corner of the rebox. Plan the framing
to allow routing the cord set to an outlet.
!
NOTE: These framing dimensions are based on
installation with 1/2" (12.7 mm) drywall.
!
NOTE: Do not install the rebox into an
air-tight enclosure. Ventilation to the unit is
recommended to improve operation.
VST130-III Installation
C
A
B
9