Clear And Sanitize A Non-Functional Instrument - Tektronix DPO2014 Instructions Manual

Clear and Sanitize a Non-Functional Instrument

Acquisition board
USB Flash Drive
Charges
DPO2000 and MSO2000 Series Declassification and Security Instructions
If your instrument is not functioning and you need to clear or sanitize it, proceed
as follows:
Only qualified personnel should perform service procedures. Read the Service
Safety Summary and the General Safety Summary in the DPO2000 and MSO2000
Series Digital Phosphor and Mixed Signal Oscilloscopes Service Manual before
performing any service procedures.
Remove the Acquisition board and return the product to Tektronix. A new
Acquisition board will be installed, and the instrument will be repaired and
adjusted as necessary.
For removal instructions, refer to the DPO2000 and MSO2000 series service
manual, part number 071-2331-XX, available on the Tektronix Web site at
www.tektronix.com/manuals.
After removal of the Acquisition board, refer to your company's internal policies
regarding handling or disposal of the board.
Remove the USB flash drive and return the instrument to Tektronix for repair.
After removal of the USB flash drive, refer to your company's internal policies
regarding handling or disposal of the flash drive.
Replacement of any missing hardware will be charged according to the rate at
the time of replacement.
9