Table of Contents
Advertisement
PPT-2620 / H
Saw Chain Adjustment
Always disconnect spark plug wire before servicing cutting
attachment. Wear gloves when handling saw chain, otherwise
serious personal injury may result.
Saw Chain Adjustment
1.
Move stop switch to STOP
position.
2.
Disconnect spark plug lead.
3.
Loosen two guide bar nuts (A)
until finger tight.
Always loosen guide bar nuts before turning the chain tension
adjuster, otherwise the clutch cover and tensioner will be damaged.
4.
Hold the bar nose up, and turn the adjuster screw (B) clockwise until
the chain fits snugly against the underside of the bar, as shown. Cold
Chain Only - turn adjuster screw CW an additional 1/8 - 1/4 turn.
Tighten both guide bar nuts with nose held up. Tighten rear nut first..
5.
Pull the chain around the guide bar by hand. Reduce the chain tension
if you feel tight spots.
6.
When chain is properly tensioned, tighten guide bar nuts securely.
Tighten guide bar nuts to 8 - 9 N•m (71 - 80 lbf•in). DO NOT over-
tighten nuts or damage may result.
X7502346700
© 11/23 ECHO Incorporated
ASSEMBLY
A
B
21
Advertisement
Table of Contents
