Table of Contents
Advertisement
PPT-2620 / H
Cutting Attachment to Drive Shaft Installation
Saw Chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury may result
1.
Loosen the two (2) screws (A)
and remove locator screw (B)
on cutting attachment.
2.
Loosen clamp knob (E) turning
counterclockwise.
3.
Pull upper tube (F) out of
fiberglass lower tube 127-152
mm (5-6 in.), then slide (F)
back into fiberglass lower tube
exposing inner drive shaft (G).
Align and join star shaped
drive end of inner drive shaft
with cutting attachment shaft.
X7502346700
© 11/23 ECHO Incorporated
ASSEMBLY
A
B
E
F
G
A
19
Advertisement
Table of Contents
