3-Foot Extension Installation; Saw Chain Tension Adjustment - Echo Power Pruner PPF-210 Operator's Manual

3-
FOOT EXTENSION INSTALLATION
(Optional)
WARNING
Saw Chain is sharp! Always wear gloves when handling cutting
attachment, otherwise serious personal injury may result.
1. Remove the cutting attachment from the Power Pruner
housing by removing the location bolt (B), loosening the (4) four
lower bolts (A) clamping the cutting attachment to the shaft
housing, sliding the cutting attachment off.
2. Loosen the 4 screws (D) on the extension clamp and slide the
extension onto the shaft housing until the hole (E) in the extension
clamp lines up with the hole (C) in the shaft housing. Insert the
#8 x 1/2 in. self-tapping screw (F) into hole (C) and tighten to snug.
3. Follow the steps outlined in Cutting Attachment to Drive Shaft
Installation to install the cutting attachment to the extension.

SAW CHAIN TENSION ADJUSTMENT

WARNING
Always wear gloves when handling saw chain, otherwise serious
personal injury may result.
To Adjust Saw Chain Tension.
1. Loosen two (2) 6 mm guide bar nuts (A) located on cutting attach-
ment using the T-wrench provided.
2. Turn the adjuster slot (B) clockwise until saw chain touches the
bottom of guide bar. Turning adjuster slot (B) counter clockwise
will loosen saw chain on guide bar.
3. Tighten guide bar nuts firmly. Move saw chain backwards on
guide bar by hand. Saw chain should move freely on guide bar if it
is in proper mesh with sprocket. If saw chain is difficult to rotate or
binds on guide bar, it is too tight.
Keep the saw chain lubricated and properly adjusted and the guide bar
nuts tightened firmly at all times.
DANGER
TM
shaft
DANGER
P P
OWER RUNER
O ' M
PERATOR S
B
A
A
F
D
E
D
C
A
TM
11
ANUAL
B