Assembly; Cutting Attachment To Drive Shaft Installation; Saw Chain Tension Adjustment - Echo Power Pruner PPF-225 Operator's Manual

ASSEMBLY

ASSEMBLY

Cutting Attachment to Drive Shaft Installation

Parts Required: Drive Shaft Assembly, Cutting Attachment.
Saw Chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury
may result
1. Loosen the two (2) screws (A) and remove locator screw (B)
on cutting attachment.
2. Slide the cutting attachment onto the shaft housing until the
hole in the neck of the cutting attachment is aligned with the
hole (C) in the housing. (It may be necessary to rotate the
saw chain slightly to align the internal pinion and drive
shaft.).
3. Insert locator screw (B) into hole (C) and tighten to snug.
4. Tighten bolts (A), clamping the cutting attachment onto the
housing.

Saw Chain Tension Adjustment

Always disconnect spark plug wire before servicing cutting
attachment. Wear gloves when handling saw chain,
otherwise serious personal injury may result.
To Adjust Saw Chain Tension
1. Move stop switch to STOP position.
2. Disconnect spark plug lead.
3. Loosen two guide bar nuts (A) until finger tight.
Always loosen guide bar nuts before turning the chain tension adjuster, otherwise the clutch cover and
tensioner will be damaged.
14
C
B
A
© 09/2013 ECHO Inc.
PPF-225
A
B
X7502308106