Adjusting The Back Height; Adjusting The Stability And The Maneuverability - Vermeiren Sagitta Installation Manual

EN
NL
4.7

Adjusting the back height

The back height of the Sagitta can be adjusted in 12 different combinations. Four by changing the
frame and 3 by changing the position of the back tube.
Frame
4.8

Adjusting the stability and the maneuverability

L
WARNING: Risk of injury – Position of rear wheels may only be adjusted by your
specialist dealer.
L
WARNING: Risk of injury – Be aware that these adjustments has influence on the
stability of the wheelchair.
L
WARNING: Risk of injury – Be sure that there is no collision with the steering wheels.
L
WARNING: Risk of injury – Brake adjustment is necessary to adjust the position of the
drive wheels.
Changing position of the back tube
Hole 1
1 230 mm
2 280 mm
3 330 mm
4 380 mm
1. Remove the back cushion.
2. Press on the button  located on the back tube.
3. Move the back tube to the desired position (refer to table 4).
4. Check that button  clicks back in the hole.
Hole 2
255 mm
305 mm
355 mm
405 mm
Table 4: Back height
The stability and maneuverability can be adjusted by
moving the axle block of the rear wheels  more to the
front or the back of the frame.
Adjust the stability and maneuverability according
following steps:
1. Loosen the upper screw  of the axle block.
2. Move the axle block  in the desired position.
3. Retighten the screw .
Installation manual
11
Sagitta, Sagitta SI
2023-07
Assembly and adjustments
Hole 3
280 mm
330 mm
380 mm
430 mm