Vermeiren Sagitta Installation Manual page 9

EN
NL
Front wheel standard fork
Change the seat height and seat angle according the following steps
change the diameter of the rear wheels skip the first four steps):
1. Remove the rear wheels (see § 4.9).
2. Change the diameter of the rear wheels.
3. Mount the rear wheels.
4. Check if the axle bushings are fastened well.
5. Screw the swivel axles of the front wheels loose.
6. Choose the correct diameter for the front wheels (refer to table 1).
7. Place the front wheels in the right hole of the front fork (table 1).
8. Install the swivel axles of the front wheels and tighten them. Check the tension in the swivel
axle so it turn smoothly, but there is no space for motion.
9. If installed properly the swivel axles of the front wheels and the ground must be perpendicular.
Check this.
10. Adjust the brakes according to § 4.3.
The Vermeiren Sagitta SI can be adjusted in 3 different seat angles without changing wheel
diameters and front wheel forks.
Seat height 495 mm
Seat height 520 mm
Seat depth
330 - 420 mm
330 - 380 mm
420 mm
330 - 420 mm
330 - 420 mm
330 - 420 mm
Table 2: Adjustable seat angles for the Sagitta SI
Installation manual
Axle block rear wheels Ⓐ
Seat angle
Seat angle (standard-table 3) + 0°
Seat angle (standard-table 3) + 2°
Seat angle (standard-table 3) + 1°
Seat angle (standard-table 3) + 3°
Do not use
Do not use
7
Sagitta, Sagitta SI
2023-07
Assembly and adjustments
(When it is not necessary to
Hole
1
2
2
3
4
5