Table of Contents
Advertisement
Functional characteristics
MIG/MAG welding
5.4.3
Welding procedure
After setting the basic parameters you can switch between the welding procedures MIG/MAG, forceArc,
wiredArc, rootArc und coldArc (if there is a corresponding combination of the basic parameters). The pro-
cess change will also change the JOB number, but the basic parameters remain unchanged.
5.4.4
Operating mode
The operating mode determines the process sequence controlled by the welding torch. Detailed descripti-
ons of the operating modes > see 5.4.14 chapter.
26
Figure 5-6
Figure 5-7
099-00HPXQ-EW501
07.05.2021
Advertisement
Table of Contents
Need help?
Do you have a question about the Control HP-XQ and is the answer not in the manual?
Questions and answers