Hitachi 65 Instruction Manual page 67

Name
LAN port
(1000BASE-T/100BASE-TX/
10BASE-T)
(NOTE1) The locations of ACT/LINK lamp and communication speed lamp differ between the optional
LAN adapter and onboard LAN.
(NOTE2) HJ-F7560-20 has two LAN ports. If you look from back side this equipment on horizontal
installation, the A port is upper side and the B port is lower side.
Table 1-1 Function of Each Part (4/5)
⚫ Option LAN adaptor (HJ-F7560-20)
Lamp
Lit in green A link is established.
Both the equipment and the remote device are powered
up and the connection over the twisted-pair Ethernet
cable is stable.
Off No link is established.
• The equipment is not physically connected to the
network.
• The switching hub is not powered up.
• The connection over the twisted-pair Ethernet cable is
not stable.
• The driver settings have some errors.
Blinking in Network data is being transmitted or received.
green The blink interval changes depending on the traffic on
the network.
Lamp
Lit in The link is established at 1000 Mbps.
orange
Lit in green The link is established at 100 Mbps.
Off The link is established at 10 Mbps. Or no link is
established.
1-11
Function
ACT/LINK lamp
Status
Communication speed lamp
Status
1. GETTING STARTED
ACT/LINK lamp
Communication speed lamp