Table of Contents
Advertisement
SAFETY INSTRUCTIONS (Continued)
⚫ Put the HDD on a shock-absorbing material such as an antistatic cushion
even for a temporary task. If you put an HDD directly on a hard surface such
as a desktop, a failure or a shorter life span of the unit or loss of data may
result due to possible jarring or shock.
⚫ Never remove the screws on an HDD while the power to the unit is on. Never
hot-swap HDDs. If you do either of these, failure of the equipment or the
drive may result.
⚫ Before you replace an HDD, make sure you shut down the OS, unplug the
power cord from the outlet, and wait for at least one minute.
⚫ When you need to replace a failed HDD in RAID1 while the power is on, see
"10.4.2 Recovery from a failure in one drive".
⚫ Install or remove an HDD only if necessary, for example, when you need to
replace an HDD due to failure. If you do it frequently, failure of the
equipment may result.
⚫ Fully insert an HDD. Loose contact and missing screws may result in
failure.
⚫ Do not give a shock to an installing HDD and the already mounted
HDD during installing. If you give a shock to an HDD, failure
of the drive may result.
⚫ Make sure you do not apply too much force to the connector of the DVD
drive and the top of the DVD drive. If you do so, failure of the DVD drive
may result.
⚫ The orientation of a rack-mounting metal fitting is fixed if it is to be attached
to the equipment. Make sure the orientation is correct.
S-15
(Page 6-15)
(Page 6-18)
(Page 6-20)
Advertisement
Table of Contents
