Advertisement
B9.
Attention:
The climbing locks and the mounting brackets must first be mounted directly above and
below the parallel switch installation location before the recess for the parallel switch is
sawn into the existing ladder.
If this is not possible, the installer must additionally attach himself to the mast with a
holding rope according to Fig. 2 in order to prevent any bending back of the ladder after
sawing and thus secure against falling.
Fig.2
Attention:
The function of the fall arrester is only guaranteed within the guide rail area secured by
climbing locks and when used as intended.
The insertion or removal of the fall arrester from the guide rail as well as the guiding over
the climbing lock with the arrester must be carried out in a secured position (for examp-
le, fixed floor, secured platform, secured hooking ladder or safety rope according to
EN 354/355).
www.honeywellsafety.com
Securing rope
7
Advertisement
