Chapter 2. Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - TP-Link TL-WR841N User Manual

Wireless n router
Table of Contents

Advertisement

Chapter 2. Connecting the Router

2.1

System Requirements

Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is
connected directly to the Ethernet.)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors
TCP/IP protocol on each PC
Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above
2.2

Installation Environment Requirements

Place the router in a well ventilated place far from any heater or heating vent
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the router
Operating Temperature: 0 ~40
Operating Humidity: 10%~90%RH, Non-condensing
2.3

Connecting the Router

Before installing the router, make sure your PC is connected to the Internet through the
broadband service successfully. If there is any problem, please contact your ISP. After that, please
install the router according to the following steps. Don't forget to pull out the power plug and keep
your hands dry.
1.
Power off your PC, Cable/DSL Modem, and the router.
2.
Locate an optimum location for the router. The best place is usually at the center of your
wireless network. The place must accord with the
3.
Adjust the direction of the antenna. Normally, upright is a good direction.
4.
Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on the router, shown in
Figure 2-1. (If you have the wireless NIC and want to use the wireless function, you can skip
this step.)
TL-WR841N/TL-WR841ND
(32 ~104 )
6
Wireless N Router
Installation Environment
Requirements.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tl-wr841nd

Table of Contents