Network; Lan - TP-Link TL-WR841N User Manual

Note:
a. The status LED on the router will light green all the time if the device has been successfully
added to the network.
b. The QSS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the QSS.
4.5

Network

Figure 4-4 the Network menu
There are three submenus under the Network menu (shown in Figure 4-4): LAN, WAN and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.

4.5.1 LAN

Choose menu "Network→LAN", you can configure the IP parameters of the LAN on the screen
as below.
MAC Address - The physical address of the router, as seen from the LAN. The value can't
be changed.
IP Address - Enter the IP address of your router or reset it in dotted-decimal notation
(factory default: 192.168.1.1).
Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
Note:
a. If you change the IP Address of LAN, you must use the new IP Address to login the router.
b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the
TL-WR841N/TL-WR841ND
Figure 4-5 LAN
21
Wireless N Router