Installing The Aa (Lr6) Batteries; Connecting An Optional Ac Adapter; Approved Ac Power Adapters; Building An External Battery Adapter Cable - Texas Instruments CBL 2 Getting Started Manual

Data collection device
Hide thumbs Also See for CBL 2:
Table of Contents

Advertisement

Do not place non-rechargeable batteries in a battery recharger.
Properly dispose of used batteries immediately.
Do not incinerate or dismantle batteries.

Installing the AA (LR6) Batteries

Follow these steps to replace the batteries:
1.
Holding the CBL 2™ upright, push the latch on the battery cover down with
your finger and pull the cover out.
2.
Replace all four AA (LR6) alkaline batteries. Be sure to position them according
to the polarity (+ and N) diagram inside the battery compartment.
3.
Replace the cover.

Connecting an Optional AC Adapter

1.
Connect one end of an approved adapter to the external power input
connection located on the bottom left side of the CBL 2.
2.
Plug the other end of the adapter into an electrical wall outlet.

Approved AC Power Adapters

The CBL 2 is designed to accept voltage input from an external AC-to-DC power
adapter that provides a regulated 6 Volts DC output when plugged into an
electrical wall outlet.
The Texas Instruments model AC-9920 power supply is an AC-to-DC power adapter
approved for use with the CBL 2. The model AC-9201 power supply can also be used
with the CBL 2. Use of other power adapters may result in RF interference and/or
unacceptable performance.
To order an adapter, call Customer Support at:
1-800-TI-CARES (1-800-842-2737).

Building an External Battery Adapter Cable

To build an external battery adapter cable, you will need a connector, 16-gauge
wire (about 6 feet), and two alligator clips.
Note: At the time of this printing, the Radio Shack™ Coaxial DC Power Plug #274-1569
(5.5mm O.D., 2.1mm I.D.) or equivalent is an acceptable connector.
1.
Identify one 3-foot length of the wire as black (ground) and solder it to the
insulated pin of the connector.
2.
Identify the other 3-foot length of wire as red and solder it to the outside of the
connector.
3.
Connect an alligator clip to the open end of each wire.
A-2
G
S
ETTING
TARTED WITH THE
CBL 2™ S
YSTEM
© 2000, 2003 T
I
EXAS
NSTRUMENTS
I
NCORPORATED

Advertisement

Table of Contents
loading

Table of Contents