Table of Contents
Advertisement
databegin
0
1 to n
dataend
0
1 to n
Note: dataselect=0, 1, 2; filtered if Filter=1-6 in Command 3. dataselect=3, 4, 5; ignore filter
setting in Command 3. Data End must be greater than or equal to Data Begin (unless Data
End=0) and both must be less than or equal to the number of samples sent to the CBL 2™ in
the last Command 3.
Command 6
System Setup
{6,command}
command
0
2
3
4
{6,command,parm}
command
5
parm
number you specify
{6,command,filter}
command
6
filter
0 to 6
© 2000, 2003 T
I
EXAS
NSTRUMENTS
I
NCORPORATED
Results
Starts sending data at first point collected
Starts sending data at the point selected
Results
Stops sending data at the last point
collected
Stops sending data at the point selected
Results
Abort sampling
Abort sampling
Turns sampling sound off (default on
power-up)
Turns sampling sound on
Results
Sets an ID number for the CBL 2 (used to
identify a specific CBL 2 when you have
multiple units linked together)
Results
Applies new filter to existing data
the number of the new filter to be applied
G
S
ETTING
TARTED WITH THE
CBL 2™ S
B-7
YSTEM
Advertisement
Table of Contents
